Positioning Rings for down-thrust clamp

EH 23310.

The positioning ring is an accessory to down-thrust clamps 23310.0050 - .0058, 23310.0083-0088 and 23310.0070.

After aligning, the clamp positioning ring is fitted on the spindle with the effect, that repeated clamping is always exactly on the same point. The positioning ring is rotating by 360° on down-thrust clamp. After mounting, the clamping claw can swing 110° to the left or right (only for the swiveling versions).

Material

  • Steel, blackened

Your selection resulted in 1 hits

h1 [mm]
e
For down-thrust clamp
Article-No.
CAD
Available
h1 [mm]:
7 mm
e:
22760.0052
For down-thrust clamp:
23310.0050-.0058/23310.0083-.0088
Article-No.:
23310.0350
CAD
Positioning Rings
  • System: V70/L12
  • h1: 7 mm
  • h2: 16 mm
  • d1: 5 mm
  • d2: 28 mm
  • l1: 43.5 mm
  • l2: 17.5 mm
  • b: 35 mm
  • e: 22760.0052
  • Weight: 32 g
More details

Assembly

Before mounting the positioning ring, pull-off the clamping claw of down-thrust clamp.

Title
Category
Type
Direct download
Download basket
The most exciting variety in the realm of workpiece clamping
Category:
Documentation
Type:
PDF
Direct download:
Download basket:
Download basket
Datasheet EH 23310. Positioning Rings – for down-thrust clamp
Category:
Datasheet
Type:
PDF
Direct download:
Download basket:
Download basket
DOC0011392__58317.pdf
Category:
Datasheet
Type:
PDF
Direct download:
Download basket:
Download basket

Further products